How to install integrated ceiling You must understand these three processes
Modern home decoration, integrated ceiling is a more common way of decoration. Because of its many features, such as simple installation, flexible arrangement, and easy maintenance, it has become the mainstream of home kitchen and bathroom ceilings. Then how do you install the integrated ceiling ? The following describes the installation process, let's take a look. How to install integrated ceiling 1, drawing and design Before installation, measurements must be performed on site, mainly to determine the distribution, height, position of facilities, and the location of ventilation windows. Then, according to the size of the room, shape a plane sketch. And the color of the gussets, the model number and the number of the host must be determined, and the amount and position of the main keel, the hook, the triangular keel, and the corner lines must be calculated. How to install integrated ceiling 2, ready to work It is necessary to first determine that the middle sandwich of the ceiling is greater than 300mm, then use a horizontal pipe to draw lines at four corners, and pop up the horizontal line. Then use an electric hammer to drill a hole in the previously determined position of the ventilation window, and then carry out the wire embedded wire. Finally, check the water pipes and gas pipes for leakage or leakage. How to install integrated ceiling 3, installation work a. The installation of the edge line should be cut according to the size of the wall surface first, then the edge line should be affixed below the horizontal line, and be marked in the hole; then use the electric hammer to drill hole, the depth can be about 30mm; then the expansion will be Pipe into the hole, according to the angle of the wall will cut the end of the line about 45 °, while fastening the edge of the line with a self-tapping screw. b. Install the main keel to play the bottom line of the wood bar first, then drill about 40mm above the bottom line, about 50mm deep; then insert the wood bar into the hole, and finally fix the wooden bar with the steel nail. Within it. c. The same is used to drill a hole with an electric hammer, then insert one end of the expansion pipe of the hook into the hole and tighten it; then, put a hook on the lower end to fix the hook and the main keel. d, then install the triangular keel, pay attention to the wall of the triangular keel and the wall to be about 305mm away, and other triangular keel 300mm can be, and finally with a hanging piece to connect the triangular keel and the main keel. e. Finally, when installing the aluminum gusset plate, please remember to bring good gloves so as not to hurt your hand. Also note that the angle of the aluminum gusset plate should be maintained and the clearance should be equal. The installation should be made from the main keel to the wall surface one by one. installation. Xiaobian conclusion: The above is the introduction of how to install integrated ceiling , I believe that after learning the above content, we should have a general understanding of how to install integrated ceiling. However, if it is still not quite certain, Xiaobian thinks that it is better to ask professional construction personnel to operate it. SDS Plus and SDS Max drill bits can be used for drilling operations in concrete, reinforced concrete, granite and similar materials. SDS-Plus has a drilling diameter of 4mm to 32mm and a drilling depth of 110mm to 1000mm; SDS-Max has a drilling diameter of 12mm to 52mm and a drilling depth of up to 1200mm. Sds Drill Bits,High Carbon Steel Drill Bits,Concrete Drill Bit,Flat Hammer Drill Bits Danyang Yongshun Tools Co.,Ltd , https://www.ysdrillbitset.com
SDS Drill Bits are available with two (properly shaped integral straight edges), three (star arrangement) or four (integral cross arrangement) inserts, made of cemented carbide. They are deeply embedded in the steel head with industrial solder and are characterized by a high degree of mechanical and heat resistance.
SDS Plus and SDS Max Bits should not only be selected based on the diameter of the drilled hole, but also their depth standard. Both of these measures are necessary to maximize productivity.